About This Product
Description This is jog type capacitive touch switch sensor module based on a touch detection IC TTP223B. TZT OE-TP capacitive touch button light touch switch module digital touch sensor LED no pole The maximum sensing distance is 8mm. ); } else { digitalWrite(LED_BUILTIN, LOW); Serial. Projected Capacitive Touch Sensor | How it works, Application & Advantages low dropout design output voltage = input voltage. Touch Dimmer Switch Non-contact Capacitive Touch Sensor Switch Module Jog/Latch Sunfounder Touch Sensor Module Here, we specify that the sensor pin will be used for input, the built-in LED will be used for output, and we start the serial communication to allow messages to be sent to the serial monitor. Working Current: 0-2A begin(9600); } Continuously, the Arduino checks if the touch sensor is activated. const int sensorPin = 7; Initialization in the setup() function. When the finger touch the corresponding location, output will be high(at quick speed mode). The touch sensor switch module, the back of the circuit board is touch-sensitive surfaces, with high sensitivity, the maximum sensing distance can reach 8mm, the working voltage supports the range of 3V-30V, and the maximum working current can reach 2A. Standby Current within 5V, about 2 microamps Working Mode: Support latch/jog (the default state is latch, press once to turn on / press again to turn into standby) Power-on State: Support power-on Boot up/standby (the default state is power-on off state). It can be installed in the module, such as plastic, glass, non-metallic material surface. Removing this resistance is the power on boost state. B point: Switching the latching mode/the jog mode, equipped with a 0ohm resistor, Connect is the... Board Size: Round diameter 2., 0CM The led light is on in the power-on state; the led light is off in the standby state.Product Information
Internet # 134435
Model # 6727394
Store SKU # 97323573791